Kyocera TASKalfa 6501i - Setting the Fuser Control Temperature

2N8/2N7
1-3-92
U161 Setting the fuser control temperature
Description
Changes the fuser control temperature.
Purpose
Normally no change is necessary. However, can be used to prevent curling or creasing of paper,
or solve a fuser problem on thick paper.
Method
1. Press the start key.
2. Select the item to be set.
Setting: [Warm Up]
1. Select the item to be set.
2. Change the setting value using the +/- keys.
3. Press the start key. The value is set.
Item No. Description
Display Description
Warm Up Control temperature except at printing
Print Control temperature during printing
Low Power Mode Heating power reduction control
Belt Mode Settings against broken fusing belt control
Ready Time Adjust Setting the Temperature to Activate Aging
Display Description
Setting
range
Initial setting
65ppm 80ppm
Ready
(Center)
Control temperature at dis-
playing Ready (Center)
130 to 200
(°C)
165 165
Ready
(Edge)
Control temperature at dis-
playing Ready (Edge)
100 to 200
(°C)
140 140
Ready
(Press)
Control temperature at dis-
playing Ready (Press)
0 to 200
(°C)
30 30
Drive
(Center)
Stable temperature during
driving (Center)
130 to 200
(°C)
170 175
Wait
(Center)
Stable temperature during
halt (Center)
130 to 200
(°C)
165 170
Low Power
(Press)
Control temperature at low
power consumption
(Press)
0 to 200
(°C)
130 130
Full Speed
Shift(Center)
Full speed shift tempera-
ture (Center)
0 to 200
(°C)
50 50
Pressure
(Press)
Pressurizing beginning
temperature (Press)
0 to 200
(°C)
150 155