Kyocera TASKalfa 6501i - Detaching and Refitting the PF Forwarding Pulley (Right), PF Paper Feed Pulley (Right) and PF Separation Pulley (Right)

2N8/2N7
1-5-24
(3) Detaching and refitting the PF forwarding pulley (right), PF paper feed pulley
(right) and PF separation pulley (right).
Procedure
1. Pull the cassette 3 completely.
2. Remove the four screws and then
remove the cassette 3.
Figure 1-5-38
3. Unhook the hook and remove the for-
warding pulley (right) from the axle.
4. Unhook the hook and remove the feed
pulley (right) from the axle.
Figure 1-5-39
Cassette 3
Screw
Screw
Screw
Screw
Hook
Paper feed
pulley (right)
Forwarding
pulley (right)