2N8/2N7-1
2-2-15
(7) Switches and sensors (document processor)
Figure 2-2-8 Switches and sensors (document processor)
1. DP open/close switch (DPOCSW) ........ Detects the opening/closing of the document processor.
2. DP interlock switch (DPILSW) .............. Breaks the safety circuit when the DP top cover is opened; resets
original misfeed detection.
3. DP original sensor (DPOS) ................... Detects the presence of an original.
4. DP lift sensor1 (DPLS1)........................ Detects the original tray reaching the upper limit.
5. DP lift sensor2 (DPLS2)........................ Detects the original tray reaching the lower limit.
6. DP original length switch (DPOLSW).... Detects the length of the original.
7. DP original width switch (DPOWSW).... Detects the width of the original.
8. DP feed sensor (DPFS) ........................ Detects primary original feed end timing.
9. DP CIS sensor (DPCS)......................... Detects the original scanning timing.
10. DP timing sensor (DPTS)...................... Detects the original scanning timing.
11. DP eject sensor (DPES) ....................... Detects an original misfeed in the original eject section.
1
11
2
7
6
3
4
8
10
9
5
Machine insideMachine front Machine rear
To Next Page
