Kyocera TASKalfa 6501i - Relay Board Maintenance; Setting of Deflection for Feeding from DP

2N8/2N7
1-3-198
U935 Relay board maintenance
Description
Sets the mode when call for service (C0060) occurs.
Purpose
Sets the machine status temporarily when call for service (C0060) occurs. However, after the set-
ting, call for service (C0060) occurs again when progress of period.
Setting
1. Press the start key.
2. Select Mode using the +/- keys.
* : Initial setting: Mode0
3. Press the start key. The setting is set.
4. Turn the main power switch off and on. Allow more than 5 seconds between Off and On.
Supplement
After removing the cause of the problem, be sure to change the setting in OFF.
U942 Setting of deflection for feeding from DP
Description
Adjusts the deflection generated when the document processor is used.
Purpose
Use this mode if an original non-feed jam, oblique feed or wrinkling of original occurs when the
document processor is used.
Setting
1. Press the start key.
2. Press the system menu key.
3. Place an original on the DP and press the start key to make a test copy.
4. Press the system menu key.
5. Select the item to be adjusted.
6. Change the setting value using the +/- keys or numeric keys.l
* : The greater the value, the larger the deflection; the smaller the value, the smaller the
deflection.
If an original non-feed jam or oblique feed occurs, increase the setting value. If wrinkling
of original occurs, decrease the value.
7. Press the start key. The value is set.
Completion
Press the stop key.
The screen for selecting a maintenance item No. is displayed.
Item No. Description
Display Description
Mode0 Setting mode: OFF
Mode1 Setting mode: ON (Usable up to three times of use)
Display Description
Setting
range
Initial
setting
Change in
value per step
Front Deflection of single-sided original -31 to 31 0 0.17 mm
Mix Deflection of mixed original -31 to 31 0 0.17 mm