Kyocera TASKalfa 6501i - Detaching and Refitting the Power Source PWB

2N8/2N7
1-5-87
(6) Detaching and refitting the power source PWB
Procedure
1. Remove the rear lower cover (see page
1-5-3).
2. Remove 2-pin relay connector and 6-
pin relay connector.
3. Release the wire saddle.
Figure 1-5-135
4. Remove two screws and the connector
mount.
Figure 1-5-136
Wire saddle
2-pin relay connector
6-pin relay connector
Screws
Connector mount