Kyocera TASKalfa 6501i - I-FAX Default Settings

2N8/2N7-2
1-2-116
i-FAX Default Settings
Use this page to enable the internet faxing.
The settings available on the page are shown below.
Item Description
Common
Settings
Transmis
sion
Local FAX Name Enter the local fax name.
TTI Selects On or Off whether to send the TTI (Transmit Terminal
Identifier) information to the other party.
TTI Position Selects the position of the TTI to be printed on the
transmitted documents.
Dept. Name Usage Set to On to use the account name as the local FAX
name.
The account name appears in place of the local FAX
name.
Retry Times Specify the number of redials from 0 to 14 times.
Recep-
tion
Media Type Sets the media type for printing the received documents.
Use MP Tray Selects whether or not to include the MP (multi purpose)
tray for auto media selection when printing received
documents. When turned [On], the MP tray will be
included as an option for auto media selection, and when
turned [Off], only the cassettes will be selected.
Reduced RX Size Specifies the printing configuration for printing a
document, which is larger than the selected paper size.
When [Same Size Override] is selected, the document
will be printed on multiple sheets of paper without
reducing the text. When [Reduction Override] is selected,
the document will be printed on one sheet whenever pos-
sible.
Receive Date/Time Selects [On] or [Off] whether to print the reception
information such as the received date, the received time,
the transmitting party's information and the number of
transmitted pages on the top of the received documents.
Duplex Printing Specifies whether or not to use the Duplex mode.
2in1 Printing Enables or disables 2 in1 reception.
FAX Settings Configure settings for FAX. For details, refer to the
Command Center RX User Guide.
i-FAX
Settings
TX/RX i-FAX Protocol
*1
Display whether an i-FAX connection is available or not.
Configure i-FAX in [i-FAX (SMTP & POP3)] on the
Protocol Settings page.
SMTP SMTP Server Name
*2
Enter the SMTP server name or SMTP server IP
address. You can enter up to 64 characters. If you enter
the server name, you must specify the IP address of the
DNS server. You can enter the DNS server IP address in
the TCP/IP settings screen. Refer to the machine’s Oper-
ation Guide for details.