Kyocera TASKalfa 6501i - Page 600

2N8/2N7
1-4-240
(7)
Abnormal noise is
heard.
Check if the rollers, pulleys and gears
operate smoothly.
Grease the bushes and gears.
Check if the following clutches are
installed correctly.
Paper feed clutch 1, 2
Assist clutch 1, 2
Paper conveying clutch
MP paper feed clutch
PF paper feed clutch 1, 2
PF paper conveying clutch 1, 2, 3
Check visually and remedy if necessary.
(8)
No primary original
feed.
Check if the surfaces of the following pul-
leys are dirty with paper powder.
DP forwarding pulley
DP feed belt
Clean with isopropyl alcohol.
Check if the following pulleys is
deformed.
DP forwarding pulley
DP original feed belt
Check visually and replace any
deformed (see page 1-5-115).
(9)
Multiple sheets of orig-
inal are fed.
Original is not correctly set. Set the original correctly.
Check if the DP separation pulley is
worn.
Replace the DP separation pulley if it is
worn (see page 1-5-119).
(10)
Originals jam.
Originals being used do not conform with
the specifications.
Use only originals conforming to the
specifications.
Check if the surfaces of the following pul-
leys are dirty with paper powder.
DP forwarding pulley
DP feed belt
Clean with isopropyl alcohol.
Check if the contact between the DP reg-
istration roller and DP registration pulley
is correct.
Check visually and remedy if necessary.
Check if the contact between the DP
upper conveying roller and DP conveying
pulley is correct.
Check visually and remedy if necessary.
Check if the contact between the DP left
conveying roller and DP conveying pulley
is correct.
Check visually and remedy if necessary.
Check if the contact between the DP right
conveying roller and DP conveying pulley
is correct.
Check visually and remedy if necessary.
Check if the contact between the DP
eject roller and DP eject pulley is correct.
Check visually and remedy if necessary.
Problem Causes/check procedures Corrective measures