Kyocera TASKalfa 6501i - Page 820

2N8/2N7
2-3-12
YC4
18 CAS1_LNG2 I 0/3.3 V DC PLSW1: On/Off
Connected to
feed PWB 2
19 CAS1_LNG1 I 0/3.3 V DC PLSW1: On/Off
20 GND - - Ground
21 CAS2_QUANT2 I 0/3.3 V DC PGS2(L): On/Off
22 CAS2_QUANT1 I 0/3.3 V DC PGS2(U): On/Off
23 CAS1_QUANT2 I 0/3.3 V DC PGS1(L): On/Off
24 CAS1_QUANT1 I 0/3.3 V DC PGS1(U): On/Off
25 LIFT_MOT1_LOCK I 0/3.3 V DC LM1 lock signal
26 LIFT_MOT2_LOCK I 0/3.3 V DC LM2 lock signal
27 CURRENT_SIG I 0/3.3 V DC Current signal
28 V-FEED_CL O 0/24 V DC PCCL: On/Off
29 COVER_OPEN I 0/3.3 V DC PCCSW: On/Off
30 FEED2_SENS I 0/3.3 V DC PFPCS1: On/Off
31 CAS1_P0 I 0/3.3 V DC FS1: On/Off
32 CAS1_LIFT_UP I 0/3.3 V DC LS1: On/Off
33 GND - - Ground
34 CAS1_EMPTY I 0/3.3 V DC PS1: On/Off
35 PICK_SOL1_RET - - Not used
36 PICK_SOL1_REM - - Not used
37 CAS2_P0 I 0/3.3 V DC FS2: On/Off
38 CAS2_LIFT_UP I 0/3.3 V DC LS2: On/Off
39 CAS2_EMPTY I 0/3.3 V DC PS2: On/Off
40 PICK_SOL2_RET - - Not used
41 PICK_SOL2_REM - - Not used
42 GND - - Ground
43 REG_SENS I 0/3.3 V DC RS: On/Off
44 FEED1_SENS I 0/3.3 V DC PCS: On/Off
45 BEND_SENS - - Not used
46 MID_MOT_PH O 0/3.3 V DC MM control signal
47 MID_MOT_REM(R
OL_CL)
O 0/3.3 V DC MM/MCL: On/Off
48 MID_MOT_CLK O 0/3.3 V DC (pulse) MM clock signal
49 MID_MOT_PD O 0/3.3 V DC MM control signal
50 ASIST_CL1 O 0/24 V DC ASCL1: On/Off
Connector Pin Signal I/O Voltage Description