3-34 Service Manual
7525-63x
Event Log
Lets the system support person print a limited set of the information contained in the Diagnostics Menu version
of the printed Event Log. For a sample of a printout, see “Event Log” on page 3-25. The limited Configuration
log and the full Diagnostics log printed versions show the same operator panel messages when they print and
follow the same layout guidelines.
To print the event log:
1. Navigate to Reports > Event Log.
2. Printing EVENT LOG appears, and the pages print.
Color Trapping
Color trapping uses an algorithm to compensate for mechanical misregistration in the printer. When small black
text or fine black lines are being printed, the printer checks to see if they are being printed on top of a colored
background. If so, rather than remove the color from beneath the black content, the printer leaves the color
around the edge of the text or line. The hole in the colored region is reduced in size, which prevents the
characteristic white gap that is caused by incorrect registration.
To adjust this setting:
1. Navigate to Color Trapping.
2. Touch or to adjust the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
Values include Off and numbers 1–5 (the default is 2). Values 1 through 5 indicate the amount of color
remaining beneath the black content. The default is each setting increments by 1/600 of an inch. The more
inaccurate the registration setting, the higher the setting needs to be adjusted. Selecting Off disables color
trapping.
Tray Insert Msg
This setting determines how many seconds the panel will display the Tray Insert message after a tray is inserted
into the printer.
To change this setting:
1. Navigate to Tray Insert.
2. Touch or to adjust the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
Panel Menus
Lets the system support person enable or disable the operator panel menus.
To change this setting:
1. Navigate to Panel Menus.
2. Touch or to change the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
To Next Page
Loading...
Need help?
General
