3-38 Service Manual
7525-63x
ADF Edge Erase
This menu item sets the size, in millimeters, of the no-print area around an ADF scan job. All copy jobs have a
two-millimeter minimum border. Copy jobs will use the setting or two millimeters, whichever is larger.
To adjust this setting:
1. Navigate to ADF Edge Erase.
2. Touch or to adjust the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
FB Edge Erase
This menu item sets the size, in millimeters, of the no print are around a flatbed scan job. All copy jobs have a
two- millimeter minimum border. Copy jobs will use the setting or two millimeters, whichever is larger
To adjust this setting:
1. Navigate to FB Edge Erase.
2. Touch or to adjust the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
Scanner Manual Registration
This item is used to manually register the flatbed and ADF on the MFP’s scanner unit. Registration should be
performed whenever the ADF unit, flatbed unit, or controller card are replaced.
To manually register the ADF:
1. Navigate to Scanner Manual Registration > Print Quick Test to print a Quick Test page.
2. To view the ADF’s current registration:
• Place the Quick Test page in the ADF with the image facing up, and touch Copy Quick Test to view
the frontside registration.
• Place the Quick Test page in the ADF with the image facing down, and touch Copy Quick Test to
view the backside registration.
3. To adjust the ADF’s registration:
• Touch ADF Front to adjust the frontside registration.
• Touch ADF Back to adjust the backside registration.
4. Touch or to adjust the settings for the Horizontal Adjust or the Top Margin.
5. Touch Submit to save the changes or touch Back to return to Scanner Manual Registration without
saving any changes.
6. Repeat step 2 to verify the adjustments.
7. Repeat steps 1–6 to make further adjustments.
To manually register the flatbed:
1. Navigate to Scanner Manual Registration > Print Quick Test to print a Quick Test page.
2. Remove all pages from the ADF.
3. Place the Quick Test page on the flatbed, and touch Copy Quick Test to view the flatbed’s current
registration. The printer performs a mono, text mode scan.
4. Touch Flatbed to adjust the flatbed’s registration.
5. Touch or to adjust the settings for the Left Margin or the Top Margin.
6. Touch Submit to save the changes, or touch Back to return to Scanner Manual Registration without
saving any changes.
7. Repeat step 3 to verify the adjustments.
8. Repeat steps 1–7 to make further adjustments.
To Next Page
Loading...
Need help?
General
