Lexmark X548 Series Service Manual

Diagnostic information 2-5
7525-63x
Go Back
Previous
Next
Error codes and messages
User status and attendance messages
User primary message Explanation
290–294 ADF scanning
jams
The scanner failed to feed one or more pages through the ADF.
1. Remove all original documents from the ADF.
Note: The message clears when the pages are removed from the ADF.
2. Do not fold or crease original documents. Straighten the edges on a level
surface.
3. Load the original documents in the ADF.
4. Adjust the ADF guides.
5. Touch Continue, jam cleared.
Adjusting color Wait for the process to complete.
Change [paper source]
to [custom type name]
Try one or more of the following:
• Touch Use current [paper source] to ignore the message and print from the
selected tray.
• Load the correct paper size and type in the tray, verify the paper size and type
settings are specified in the printer control panel Paper menu, and then touch
Paper changed, continue.
• Touch Cancel job to cancel the print job.
Change [paper source]
to [custom type name]
load [orientation]
Change [paper source]
to [custom string]
Change [paper source]
to [custom string] load
[orientation]
Change [paper source]
to [paper size]
Change [paper source]
to [paper size] load
[orientation]
Change [paper source]
to [paper size] [paper
type]
Change [paper source]
to [paper size] [paper
type] load [orientation]
Close front door Close the front door of the printer.
Insert Tray [x] Insert the specified tray into the printer.
Fax Station Name not
set up. Contact system
administrator.
The Fax Station Name has not been entered. Sending and receiving faxes is
disabled until fax is configured properly.
Try one or more of the following:
• Touch Continue to clear the message.
• Complete the Analog Fax Setup. If the message appears again, then contact
your system support person.
Fax Station Number not
set up. Contact system
administrator.
The Fax Station Number has not been entered. Sending and receiving faxes is
disabled until fax is configured properly.
Try one or more of the following:
• Touch Continue to clear the message.
• Complete the Analog Fax Setup. If the message appears again, then contact
your system support person.
Memory full, cannot
print faxes
There is not enough memory to print the fax job.
Touch Continue to clear the message without printing. Held faxes will attempt to
print after the printer has been restarted.

Lexmark X548 Series Specifications

General

Brand	Lexmark
Model	X548 Series
Category	All in One Printer
Language	English