2-6 Service Manual
7525-63x
No analog phone line
connected to modem,
fax is disabled
The analog phone line was not detected; the fax is disabled. Connect the printer to
an analog phone line, and then touch Continue.
Some held jobs were
not restored
Touch Continue to delete the specified job.
Note: Held jobs that are not restored stay on the hard disk and are inaccessible.
37 Insufficient memory,
some held jobs will not
be restored
The printer deleted some held jobs in order to process current jobs.
Touch Continue to clear the message.
57 Configuration
change, some held jobs
were not restored
Something has changed in the printer to invalidate the held jobs. Possible changes
include:
• The printer firmware has been updated.
• Paper input options needed for the print job were removed.
• The print job was created using data from a device in the USB port and the
device is no longer in the USB port.
• The printer hard disk contains print jobs that were stored while installed in a
different printer model.
Touch Continue to clear the message.
Load [src] with [custom
type name]
Try one or more of the following:
• Load the specified paper in the tray or feeder.
• Touch Paper loaded, continue to clear the message and continue printing.
If the printer finds a tray that has the correct paper type and size, it feeds from
that tray. If the printer cannot find a tray with the correct paper type and size, it
prints from the default paper source.
• Cancel the print job.
Load [src] with [custom
string]
Load [src] with [size]
Load [src] with [type]
[size]
Load Manual Feeder
with [custom type name]
Try one or more of the following:
• Load the specified paper in the manual feeder.
• Touch Prompt each page, paper loaded or Do not prompt, paper loaded to
clear the message and continue printing.
• Touch Automatically select paper to use the paper loaded in the tray.
• Cancel the print job.
Load Manual Feeder
with [custom string]
Load Manual Feeder
with [paper size]
Load Manual Feeder
with [paper type] [paper
size]
Remove paper from
standard output bin
Remove the stack of paper from the standard exit bin.
Remove packaging
material, [area name]
Remove any remaining packaging material from the specified location.
Error reading USB
drive. Remove drive.
An unsupported USB device has been inserted. Remove the USB device, and then
install a supported one.
Error reading USB hub.
Remove hub.
An unsupported USB hub has been inserted. Remove the USB hub, and then install
a supported one.
Unsupported camera
mode, unplug camera
and change mode
The camera mode does not support PictBridge.
Unplug the camera, change the mode, and plug the camera back into the printer.
Unsupported disk An unsupported disk has been inserted. Remove the unsupported disk, and then
install a supported one.
30.xx Missing [color]
cartridge and/or [color]
imaging kit
Try one or more of the following:
• Remove and reinstall the specified toner cartridge or imaging kit. For
instructions on removing a toner cartridge or imaging kit, touch More
information.
• Install a new toner cartridge or imaging kit, following the instruction sheet that
came with the replacement part.
User status and attendance messages
User primary message Explanation
To Next Page
Loading...
