Lexmark X548 Series - USB Pnp; Automatically Display Error Screens; Exit Config Menu

3-42 Service Manual
7525-63x
Go Back
Previous
Next
USB PnP
This setting is used to improve the MFP’s compatibility with the host PC.
Note: Some PCs contain chipsets that may be incompatible with this MFP.
To change this setting:
1. Navigate to USB PnP.
2. Touch or to change the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
Automatically Display Error Screens
To change this setting:
1. Navigate to Automatically Display Error Screens.
2. Touch or to change the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
Exit Config Menu
This setting appears as a button on the bottom right-hand corner of the display and is always accessible from
the Configuration Menu.
Touch this to exit the Configuration Menu. The printer performs a POR and starts in normal mode.