Diagnostic aids 3-39
7525-63x
Disable Scanner
This menu item is used to disable the MFP scanner if it is malfunctioning. The MFP must be powered off and on
for the new settings to take effect.
To change this setting:
1. Navigate to Disable Scanner.
2. Touch or to change the setting.
3. Touch Submit to save the changes, or touch Back to return to the Configuration Menu without saving any
changes.
Jobs On Disk
This setting allows you to delete buffered jobs saved on the disk.
To delete jobs saved on the disk:
1. Navigate to Jobs On Disk.
2. Touch Delete to delete the jobs, or touch Do not delete to return to the Configuration Menu.
Disk Encryption
This setting controls whether the device encrypts the information that it writes to the hard disk.
Note: The device deletes all information from the hard disk whenever this setting’s value is changed.
Erase All Information on Disk
Note: Due to the lengthy amount of time required to wipe the entire hard disk, a wipe should not be initiated
unless it is absolutely unavoidable or unless the device can remain offline for several hours without
inconveniencing users. A disk wipe should not be initiated if the hard disk contains downloaded fonts, macros, or
held jobs that should not be erased.
To erase all information on disk:
1. Navigate to Erase All Information on Disk.
2. Select a disk wipe method:
• Single Pass Erase—Initiates a one-time, immediate single pass wipe of the entire hard disk.
• Multiple Pass Erase—Initiates a one-time, immediate multiple pass wipe of the entire hard disk.
Wipe All Settings
This setting makes any sensitive information that may exist on the printer’s volatile or non-volatile storage
completely indecipherable.
To wipe all settings:
1. Navigate to Wipe All Settings.
2. Erase all information on the hard disk? This will erase all settings, solutions, and jobs on
this device appears. Touch Yes to continue, or touch No to return to the Configuration Menu.
To Next Page
Loading...
Need help?
General
