Diagnostic aids 3-37
7525-63x
NumPad Job Assist
This setting determines if a user can configure and initiate a job using the panel’s hard buttons.
To change this setting:
1. Navigate to NumPad Job Assist.
2. Touch or to change the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
Format Fax Storage
This setting allows the user to format non volatile fax storage memory.
To format the fax storage:
1. Navigate to Format Fax Storage.
2. Touch Yes to continue, or touch No to return to the Configuration Menu.
3. While formatting is taking place, Formatting fax flash DO NOT POWER OFF appears. After formatting is
complete, the display returns to the Configuration Menu.
Fax Storage Location
To change this setting:
1. Navigate to Fax Storage Location.
2. Touch or to change the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
Automatic Color Adjust
Sets the suggested number of pages which the printer should print between consecutive calibrations.
Selections are Off and the values between 100 and 1000 in increments of 50. The default is 500 pages.
If the printer exceeds the set value while printing a job, it completes the current job and any other jobs received
while printing the current job before it initiates a calibration. The printer does not cancel or suspend an active job
in order to perform a calibration. If a user is using the menus, including the Configuration Menu and the
Diagnostics Menu, an automatic color adjust calibration does not occur.
When an event other than page count triggers this calibration, the count that monitors the maximum number of
pages printed will be reset. For example, if the user replaces an empty toner cartridge, the next time the printer
is started, it will sense the new cartridge and perform the automatic color adjustment, even though the page
counter for Auto Color Adj is fewer than required. The Auto Color Adj page counter is then reset.
Note: An automatic color adjust can also be initiated manually. This calibration procedure should be performed
when the MFPs internal print settings are changed. To perform and automatic color adjust, perform the following
steps:
To adjust this setting:
1. Navigate to Automatic Color Adjust.
2. Touch or to adjust the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
To Next Page
Loading...
Need help?
General
