Lexmark X548 Series - Page 52

2-8 Service Manual
7525-63x
Go Back
Previous
Next
54 Standard network
software error
Try one or more of the following:
• Touch Continue to continue printing.
• Turn the printer off and then back on to reset the printer.
• Upgrade (flash) the network firmware in the printer or print server.
54 Network [x] software
error
Try one or more of the following:
• Touch Continue to continue printing.
• Turn the printer off, wait for about 10 seconds, and then turn the printer back on.
• Upgrade (flash) the network firmware in the printer.
56 Standard USB port
disabled
Try one or more of the following:
• Touch Continue to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu item is not set to Disabled.
58 Too many flash
options installed
1. Turn the printer off.
2. Unplug the power cord from the wall outlet.
3. Remove the excess flash memory.
4. Connect the power cord to a properly grounded outlet.
5. Turn the printer back on.
58 Too many trays
attached
1. Turn the printer off.
2. Unplug the power cord from the wall outlet.
3. Remove the additional trays.
4. Connect the power cord to a properly grounded outlet.
5. Turn the printer back on.
59 Incompatible tray [x] Try one or more of the following:
• Remove the specified tray.
• Touch Continue to clear the message and continue printing without using the
specified tray.
61 Remove defective
disk
Try one or more of the following:
• Touch Continue to clear the message and continue printing.
• Install a different printer hard disk before performing any operations that require
a printer hard disk.
62 Disk full Try one or more of the following:
• Touch Continue to clear the message and continue processing.
• Delete fonts, macros, and other data stored on the printer hard disk.
• Install a printer hard disk with larger capacity.
63 Unformatted disk Try one or more of the following:
• Touch Continue to clear the message and continue printing.
• Format the printer hard disk.
If the error message remains, the hard disk may be defective and may require
replacing.
82.xx Waste toner bottle
nearly full
Order a replacement waste toner bottle immediately.
1. Replace the waste toner bottle. For instructions on installing the waste toner
bottle, touch More Information.
2. Touch Continue to clear the message and continue printing.
84.xx [color] imaging kit
missing
Install the specified color imaging kit, following the instruction sheet that came with
the replacement part.
84 unsupported [color]
imaging kit
Remove the specified imaging kit, and then install a supported one.
User status and attendance messages
User primary message Explanation