2-12 Service Manual
7525-63x
291.00 Scanner Jam,
remove all originals
from the scanner
Scanner ADF detects paper at the
second scanner sensor while the ADF
is in an idle state.
Open the ADF cover to access the jam
area. Remove all the jammed pages. See
Go to “291.xx ADF paper jams” on
page 3-54.
291.01 Scanner Jam,
remove all originals
from the scanner
This message is posted if a jam is
detected at the first scanner sensor.
Open the ADF cover to access the jam
area. Remove all the jammed pages. See
Go to “291.xx ADF paper jams” on
page 3-54.
292 Scanner jam,
remove all originals
from the scanner
This message appears if the ADF
cover is open while paper is fed
through the ADF.
Remove the paper from the ADF, and
close the ADF cover. If the error recurs, go
to “ADF cover open service check” on
page 2-62.
293 Replace all
originals if restarting
job
No paper sensed in the ADF. Ensure that the paper present actuator is
in the correct position. Go to “ADF paper
jam service check” on page 2-63.
293.02 Flatbed cover
open
The MFP senses that the flatbed cover
is open.
Close the flatbed cover. Go to “ADF cover
open service check” on page 2-62.
294.04 Scanner jam,
remove all originals
from the scanner
Jam at the ADF exit sensor. Remove all paper from the ADF. If the
error recurs, go to “ADF paper jam
service check” on page 2-63.
294.05 Scanner jam,
remove all originals
from the scanner
A jam is detected at the ADF exit
sensor.
2xx paper jam messages
Error code Description Action
To Next Page
Loading...
Need help?
General
