NEC ELECTRA ELITE IPK II - Page 605

Document Revision 1 Electra Elite IPK II
2 - 570 Program 91 : IPK II Wireless DECT PS Entry
Conditions
None
Feature Cross Reference
J Electra Elite IPK II Wireless DECT
Telephone Programming Instructions
To enter data for Program 91-06:
1. Enter the programming mode.
2. 90 27
3. To have the system automatically assign a port number to the telephone, press
0 then HOLD. This assigns an available port within the range of 256~512.
To manually select a port number, enter an available port number (002~512)
then press HOLD.
 The display shows IPEI?. The IPEI (International Portable Equipment Identity) is a
unique number embedded into each Electra Elite IPK II Wireless DECT phone.
4. Enter the IPEI number for the Electra Elite IPK II Wireless DECT telephone or
enter
, as a wild character and the system will automatically retrieve the number
for the phone being set up. Press HOLD. When the display shows
“Ready?(1:Yes)”, press 1 then HOLD.
 The IPEI number is the 13-digit serial number which is located on the label in the phone’s
battery compartment.
5. The display shows the port number assigned to the telephone and the 4-digit
AC (Authentication Code) number.
DO NOT PRESS HOLD at this point or the
subscription will be cancelled.
6. Using the Electra Elite IPK II Wireless DECT phone to be registered, press the
Menu key then press the left arrow key twice to display the
Login option. Press
OK.
7. Press the Right Arrow key once to display the
Subscription Create option. Press
OK.
8. The Wireless phone will search for the DSIU ETU and display the ETU ID
number once found.
 This may take a few seconds. If the ID number does not appear, check Program 90-27-01
to make sure the ETU is recognized.
90-27-01
Port(0:Auto)?
back
↑ ↓ select