Electra Elite IPK II Document Revision 1
Electra Elite IPK II Programming Manual 2 - 571
9. Press OK.
10. Enter the 4-digit AC number displayed in Step 4 (Program 91-06-01) and press
OK.
11. Once the telephone has been registered, the telephone will beep and (
((.)))
appears in the lower left-hand corner. Program 91-06-01 shows COMPLETED.
Press HOLD and register another telephone if required or continue with the next
step.
Prior to deleting an Electra Elite IPK II Wireless DECT phone from the system using
Program 91-07-01 : DECT Deleting Access Rights, make sure the DSIU ETU is
installed in the system. If the DSIU is removed when Program 91-07-01 is run, the system
will retain the DECT setting. This will prevent the Electra Elite IPK II Wireless DECT
telephone(s) from being registered in the system again.
12. Press MSG until you have exited that series programming section.
To Next Page
Loading...
