NETGEAR M4200

Security Management
363
Managed Switches
5. Configure EXEC authorization for Telnet.
6. Verify that EXEC authorization is set up for Telnet.
7. Using Linux on the RADIUS server, configure a user named eric as an administrator in the
user file for FreeRADIUS.
Note: Instead, you can also configure a user named eric with Cisco-AVPair
"shell:priv-lvl=15".
(Netgear Switch) (Config)#line telnet
(Netgear Switch) (Config-telnet)# authorization exec execList
(Netgear Switch) (Config-telnet)#exit
(Netgear Switch) #show authorization methods
Command Authorization Method Lists
-------------------------------------
dfltCmdAuthList : none
Line Command Method List
--------- ---------------------
Console dfltCmdAuthList
Telnet dfltCmdAuthList
SSH dfltCmdAuthList
Exec Authorization Method Lists
-------------------------------------
dfltExecAuthList : none
execList : radius
Line Exec Method List
--------- ---------------------
Console dfltExecAuthList
Telnet execList
SSH dfltExecAuthList
eric Cleartext-Password := "testing"
Service-Type = Administrative-User,
eric Cleartext-Password := "testing"
Service-Type = Login-User,
Cisco-AVPair = "shell:priv-lvl=15