NETGEAR M4200

ACLs
216
Managed Switches
4. View the configuration.
Web Interface: Configure an IPv6 ACL
1. Create the access control list with the name ipv6-acl.
a. Select Security > ACL > Advanced > IPv6 ACL.
b. In the IPv6 ACL Table, in the IPv6 ACL field, enter ipv6-acl.
(Netgear Switch) #show ipv6 access-lists
Current number of all ACLs: 1 Maximum number of all ACLs: 100
IPv6 ACL Name Rules Direction Interface(s) VLAN(s)
--------------------- ----- --------- ------------- ------------
ipv6-acl 3 inbound 1/0/1
(Netgear Switch) #show ipv6 access-lists ipv6-acl
ACL Name: ipv6-acl
Inbound Interface(s): 1/0/1
Rule Number: 1
Action......................................... permit
Protocol....................................... 255(ipv6)
Source IP Address.............................. 2001:DB8:C0AB:AC11::/64
Destination IP Address......................... 2001:DB8:C0AB:AC14::/64
Rule Number: 2
Action......................................... permit
Protocol....................................... 6(tcp)
Source IP Address.............................. 2001:DB8:C0AB:AC11::/64
Destination IP Address......................... 2001:DB8:C0AB:AC13::/64
Destination L4 Port Keyword.................... 23(telnet)
Rule Number: 3
Action......................................... permit
Protocol....................................... 6(tcp)
Source IP Address.............................. 2001:DB8:C0AB:AC11::/64
Destination L4 Port Keyword.................... 80(www/http)