NETGEAR M4200 User Manual

IPv6 Interface Configuration
552
Managed Switches
2. Enable DHCPv6 on the interface 1/0/23.
3. Show the ipv6 address assigned from 1/0/23.
Web Interface: Configure DHCPv6 mode on routing interface
1. Enable IPv6 unicast globally.
a. Select Routing > IPv6 > Basic > Global Configuration.
(Netgear Switch) (Config)#interface 1/0/23
(Netgear Switch) (Interface 1/0/23)#routing
(Netgear Switch) (Interface 1/0/23)#ipv6 enable
(Netgear Switch) (Interface 1/0/23)#ipv6 address dhcp
(Netgear Switch) (Interface 1/0/23)
(Netgear Switch) #show ipv6 interface 1/0/23
IPv6 is enabled
IPv6 Prefix is ................................ FE80::E291:F5FF:FE06:2BF6/128
2000::1D5C:7CFE:828F:8144/128 [DHCP]
Routing Mode................................... Enabled
IPv6 Enable Mode............................... Enabled
Administrative Mode............................ Enabled
IPv6 Operational Mode.......................... Enabled
Bandwidth...................................... 1000000 kbps
Interface Maximum Transmit Unit................ 1500
Router Duplicate Address Detection Transmits... 1
Address DHCP Mode.............................. Enabled
Router Advertisement NS Interval............... 0
Router Advertisement Lifetime.................. 1800
Router Advertisement Reachable Time............ 0
Router Advertisement Interval.................. 600
Router Advertisement Managed Config Flag....... Disabled
Router Advertisement Other Config Flag......... Disabled
Router Advertisement Router Preference......... medium
Router Advertisement Suppress Flag............. Disabled
IPv6 Destination Unreachables.................. Enabled

NETGEAR M4200 Specifications

General

Brand	NETGEAR
Model	M4200
Category	Switch
Language	English