NETGEAR M4200

Security Management
306
Managed Switches
Set the Dynamic and Static Limit on Port 1/0/1
The example is shown as CLI commands and as a web interface procedure.
CLI: Set the Dynamic and Static Limit on Port 1/0/1
Web Interface: Set the Dynamic and Static Limit on Port 1/0/1
1. Select Security > Traffic Control > Port Security >Port Administrator.
A screen similar to the following displays.
b. Under Port Security Configuration, next to Port Security Mode, select the Enable
radio button.
c. Click Apply to save the settings.
2. Set the dynamic and static limit on the port 1/0/1:
a. Select Security > Traffic Control > Port Security >Interface Configuration.
(Netgear Switch) (Config)#port-security
Enable port-security globally
(Netgear Switch) (Config)#interface 1/0/1
(Netgear Switch) (Interface 1/0/1)#port-security
Enable port-security on port 1/0/1
(Netgear Switch) (Interface 1/0/1)#port-security max-dynamic 10
Set the dynamic limit to 10
(Netgear Switch) (Interface 1/0/1)#port-security max-static 3
Set the static limit to 3
(Netgear Switch) (Interface 1/0/1)#ex
(Netgear Switch) (Config)#ex
(Netgear Switch) #show port-security 1/0/1
Admin Dynamic Static Violation
Intf Mode Limit Limit Trap Mode
------ ------- ---------- --------- ----------
1/0/1 Disabled 10 3 Disabled