EasyManuals Logo

NETGEAR M4200 User Manual

NETGEAR M4200
688 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #551 background imageLoading...
Page #551 background image
IPv6 Interface Configuration
551
Managed Switches
e. Click Apply.
6. Assign an IPv6 address to the routing VLAN.
a. Select Routing > IPv6 > Advanced > Prefix Configuration.
A screen similar to the following displays.
b. In the Interface field, select 0/4/2.
c. In the IPv6 Prefix field, enter 2000::1.
d. In the Length field, enter 64.
e. In the EUI64 field, select Disable.
f. Click Add.
Configure DHCPv6 Mode on the Routing Interface
The routing interface supports DHCPv6 mode, which can get the IPv6 address from a
DHCPv6 server (address allocation).
Note: Before you enable DHCPv6 mode, you must disable IPv6 unicast
mode globally.
CLI: Configure DHCPv6 mode on routing interface
1. Enable IPv6 unicast globally.
(Netgear Switch) (Config)#ipv6 unicast-routing

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR M4200 and is the answer not in the manual?

NETGEAR M4200 Specifications

General IconGeneral
BrandNETGEAR
ModelM4200
CategorySwitch
LanguageEnglish

Related product manuals