NETGEAR M4200

Tools
415
Managed Switches
CLI: transport output telnet
Web Interface: Configure Telnet
1. Select Security > Access > Telnet.
A screen similar to the following displays.
(Netgear Switch) (Config)#lineconfig ?
<cr> Press Enter to execute the command.
(Netgear Switch) (Config)#lineconfig
(Netgear Switch) (Line)#transport ?
input Displays the protocols to use to connect to a
specific line of the router.
output Displays the protocols to use for outgoing
connections from a line.
(Netgear Switch) (Line)#transport output ?
telnet Allow or disallow new telnet sessions.
(Netgear Switch) (Line)#transport output telnet ?
<cr> Press Enter to execute the command.
(Netgear Switch) (Line)#transport output telnet
(Netgear Switch) (Line)#