NETGEAR M4200

Syslog
429
Managed Switches
Web Interface: Show Logging Hosts
Select Monitoring > Logs > Sys Log Configuration. A screen similar to the following
displays.
Configure Logging for a Port
The example is shown as CLI commands and as a web interface procedure.
CLI: Configure Logging for the Port
(Netgear Switch) #config
(Netgear Switch) (Config)#logging ?
buffered Buffered (In-Memory) Logging Configuration.
cli-command CLI Command Logging Configuration.
console Console Logging Configuration.
host Enter IP Address for Logging Host
syslog Syslog Configuration.
(Netgear Switch) (Config)#logging host ?
<hostaddress> Enter Logging Host IP Address
reconfigure Logging Host Reconfiguration
remove Logging Host Removal
(Netgear Switch) (Config)#logging host 192.168.21.253 ?
<cr> Press Enter to execute the command.
<port> Enter Port Id