NETGEAR M4200 User Manual

RIP
91
Managed Switches
Enable Routing for Ports
The example is shown as CLI commands and as a web interface procedure.
CLI: Enable Routing and Assigning IP Addresses for Ports
1/0/2 and 1/0/3
Web Interface: Enable Routing for the Ports
1. Assign IP address 192.150.2.1/24 to interface 1/0/2.
a. Select Routing > Advanced > IP Interface Configuration.
A screen similar to the following displays.
b. Scroll down and select the Interface 1/0/2 check box. Now 1/0/2 appears in the
Interface field at the top.
c. Enter the following information:
• In the IP Address Configuration Method field, select Manual.
• In the IP Address field, enter 192.150.2.1.
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#routing
(Netgear Switch) (Interface 1/0/2)#ip address 192.150.2.1 255.255.255.0
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#routing
(Netgear Switch) (Interface 1/0/3)#ip address 192.150.3.1 255.255.255.0
(Netgear Switch) (Interface 1/0/3)#exit
(Netgear Switch) (Config)#exit

NETGEAR M4200 Specifications

General

Brand	NETGEAR
Model	M4200
Category	Switch
Language	English