Syslog
426
Managed Switches
Show Logging Buffered
The example is shown as CLI commands and as a web interface procedure.
CLI: Show Logging Buffered
The priority (that is, the number that is stated in angle brackets before each logging message,
for example, <14> in the previous example) is calculated by multiplying the facility number by
8 and adding the numerical value of the severity. If you know the priority, you can determine
the facility and severity in the following ways:
• Facility = Priority divided by 8. The whole number is the facility. For example, if the priority
is 14, divide 14 by 8. The result is 1.75. The whole number is 1, which is the facility.
• Severity = Priority minus 8. For example, if the priority is 14, subtract 8 from 14. The result
is 6, which is the severity.
(Netgear Switch) #show logging buffered ?
<cr> Press Enter to execute the command.
(Netgear Switch) #show logging buffered
Buffered (In-Memory) Logging : enabled
Buffered Logging Wrapping Behavior : On
Buffered Log Count : 3949
<14> Jan 13 00:42:58 172.26.2.129-1 CLI_WEB[101123540]: emweb_common_custom.c(119)
6497 %% HTTP Session 11 ended for user admin connected from 10.120.5.28
<14> Jan 13 00:36:21 172.26.2.129-1 UNITMGR[102633148]: unitmgr.c(6898) 6496 %% Copy
of running configuration to backup unit complete
<14> Jan 13 00:34:21 172.26.2.129-1 UNITMGR[102633148]: unitmgr.c(6898) 6494 %% Copy
of running configuration to backup unit complete
<13> Jan 13 00:33:45 172.26.2.129-1 TRAPMGR[102518604]: traputil.c(701) 6492 %% Link
Up: tunnel0
<13> Jan 13 00:33:44 172.26.2.129-1 TRAPMGR[102518604]: traputil.c(701) 6491 %% Link
Down: tunnel0
<13> Jan 13 00:33:44 172.26.2.129-1 TRAPMGR[102518604]: traputil.c(701) 6490 %% Link
Up: tunnel0
To Next Page
Loading...
