NETGEAR M4200

Link Dependency
660
Managed Switches
CLI: Create a Link State Group
1. Create a link state group with group number 1.
2. Configure port 1/0/1 as an upstream link.
3. Configure port 1/0/5 as a downstream link.
4. Display the status of the link state group with group number 1.
Web Interface: Create a Link State Group
1. Configure the action for link state group with group number 1.
a. Select System > Link Dependency > Link Dependency Group Configuration.
A screen similar to the following displays.
(Netgear Switch) (Config)#link state group 1 action down
(Netgear Switch) (Config)#interface 1/0/1
(Netgear Switch) (Interface 1/0/1)#link state group 1 upstream
(Netgear Switch) (Interface 1/0/1)#interface 1/0/5
(Netgear Switch) (Interface 1/0/5)#link state group 1 downstream
(Netgear Switch) (Interface 1/0/5)#exit
(Netgear Switch) #show link state group 1
GroupId Downstream Interfaces Upstream Interfaces Link Action Group State
------- ---------------------- -------------------- ------------ -----------
1 1/0/5 1/0/1 Link Down Up