NETGEAR M4200

MAB
391
Managed Switches
CLI: Reduce the Authentication Time for MAB
Change the guest VLAN period timer to 10 seconds using the CLI:
Web Interface: Reduce the Authentication Time for MAB
Change the guest VLAN period timer to 10 seconds using the web interface:
1. Select Security > Port Authentication > Advanced > Port Authentication.
A screen similar to the following displays.
2. Select the check box that corresponds to port 0/1.
The table heading displays the information for port 0/1.
3. In the Guest VLAN Period field, enter 10
Leave the other settings on the screen at the default value.
4. Click Apply.
(Netgear Switch) #config
(Netgear Switch) (Config)# interface 1/0/1
(Netgear Switch) (Interface 1/0/1)#dot1x timeout guest-vlan-period 10