IGMP Snooping and Querier
283
Managed Switches
Multicast Router Using VLAN
The example is shown as CLI commands and as a web interface procedure.
CLI: Configure the Switch with a Multicast Router Using VLAN
This example configures the interface to forward only the snooped IGMP packets that come
from VLAN ID (<VLAN Id>) to the multicast router attached to this interface.
Web Interface: Configure the Switch with a Multicast Router
Using VLAN
1. Select Switching > Multicast > Multicast Router VLAN Configuration.
A screen similar to the following displays.
2. Under Multicast Router VLAN Configuration, scroll down and select the Interface 1/0/3
check box.
3. Enter the following information in the Multicast Router VLAN Configuration.
• In the VLAN ID field, enter 2.
• In the Multicast Router field, select Enable.
4. Click Apply.
(Netgear Switch)(Interface 1/0/3)# set igmp mrouter 2
To Next Page
Loading...
