NETGEAR M4200

DHCPv6 Server
484
Managed Switches
3. Enable the IPv6 DHCP server on interface 1/0/1.
Web Interface: Configure a Stateful DHCPv6 Server
1. Enable ipv6 routing.
a. Select Routing > IPv6 > Basic > Global Configuration.
A screen similar to the following displays.
b. For IPv6 Unicast Routing, select the Enable radio button.
c. Click Apply to save the settings.
2. Enable IPv6 routing on interface 1/0/1.
a. Select Routing > IPv6 > Advanced > Interface Configuration.
(Netgear Switch) (Config)#interface 1/0/1
(Netgear Switch) (Interface 1/0/1)#routing
(Netgear Switch) (Interface 1/0/1)#ipv6 address 2001:1:2::1/64
(Netgear Switch) (Interface 1/0/1)#ipv6 enable
(Netgear Switch) (Interface 1/0/1)#ipv6 dhcp server ipv6_server
(Netgear Switch) (Interface 1/0/1)#exit