NETGEAR M4200

DHCP L2 Relay and L3 Relay
607
Managed Switches
Web Interface: Enable DHCP L2 Relay
1. Create VLAN 200.
a. Select Switching > VLAN > Basic > VLAN Configuration.
A screen similar to the following displays.
b. In the VLAN ID field, enter 200.
c. In the VLAN Type field, select Static.
d. Click Add.
2. Add ports to VLAN 200.
a. Select Switching > VLAN > Advanced > VLAN Membership.
A screen similar to the following displays.
b. In the VLAN ID field, select 200.
c. Click Unit 1. The ports display.
d. Click the gray boxes under ports 4, 5, and 6 until U displays.
The U specifies that the egress packet is untagged for the port.
e. Click Apply.
3. Specify the PVID on ports 1/0/4, 1/0/5 and 1/0/6.
a. Select Switching > VLAN > Advanced > Port PVID Configuration.