NETGEAR M4200

DHCP L2 Relay and L3 Relay
608
Managed Switches
A screen similar to the following displays.
b. Scroll down and select the Interface 1/0/4, 1/0/5, and 1/0/6 check boxes.
c. In the PVID (1 to 4093) field, enter 200.
d. Click Apply to save the settings.
4. Enable DHCP L2 relay on VLAN 200.
a. Select System > Services > DHCP L2 Relay > DHCP L2 Relay Configuration.
A screen similar to the following displays.
b. For Admin Mode, select the Enable radio button.
c. Scroll down and select the VLAN ID 200 check box.
d. Enter the following information:
• In the Admin Mode field, select Enable.
• In the Circuit ID Mode field, select Enable.
• In the Remote ID String field, enter rmt_id.
e. Click Apply to save the settings.
5. Enable DHCP L2 Relay on interfaces 1/0/4,1/0/5, and 1/0/6.
a. Select System > Services > DHCP L2 Relay > DHCP L2 Relay Interface
Configuration.