Captive Portals
672
Managed Switches
Web Interface: Configure RADIUS as the Verification Mode
1. Select Security > Control > Captive Portal > CP Configuration.
A screen similar to the following displays.
2. Scroll down and select the CP 1 check box. Now CP 1 appears in the CP ID field at the top.
3. Enter the following information:
• In the Verification field, select RADIUS.
• In the Radius Auth Server field, enter the RADIUS server name
Default-RADIUS-Server.
4. Click Apply.
SSL Certificates
A captive portal instance can be configured to use the HTTPS protocol during its user
verification process. The connection method for HTTPS uses the Secure Sockets Layer
(SSL) protocol, which requires a certificate to provide encryption. The certificate is presented
to the user at connection time.
In software release 8.0 (or newer), the captive portal uses the same certificate that is used for
secure HTTP connections. You can generate this certificate using a CLI command. If a
captive portal instance is configured for the HTTPS protocol and there is not a valid certificate
present on the system, the captive portal instance status will show Disabled with an
appropriate reason code.
To Next Page
Loading...
Need help?
General