Security Management
365
Managed Switches
Configure Telnet EXEC Accounting by RADIUS Server
RADIUS accounting supports EXEC mode but does not support command mode.
(Netgear Switch)(Config)#radius server host acct 10.100.5.13
(Netgear Switch)(Config)#radius server key acct 10.100.5.13
Enter secret (64 characters max):12345678
Re-enter secret:12345678
(Netgear Switch)(Config)#radius accounting mode
(Netgear Switch)(Config)#aaa accounting exec default stop-only radius
(Netgear Switch)#show radius
Number of Configured Authentication Servers.... 0
Number of Configured Accounting Servers........ 1
Number of Named Authentication Server Groups... 0
Number of Named Accounting Server Groups....... 1
Number of Retransmits.......................... 4
Timeout Duration............................... 5
RADIUS Accounting Mode......................... Enable
RADIUS Attribute 4 Mode........................ Disable
RADIUS Attribute 4 Value....................... 0.0.0.0
(Netgear Switch) #show accounting methods
AcctType MethodName MethodType Method1 Method2
--------- ---------------- ------------- --------- ---------
Exec dfltExecList stop-only radius
Commands dfltCmdList stop-only tacacs
Line EXEC Method List Command Method List
--------- -------------------- --------------------
Console none none
Telnet dfltExecList dfltCmdList
SSH none none
HTTPS none none
HTTP none none
To Next Page
Loading...
