NETGEAR M4200

OSPF
128
Managed Switches
c. Enter the following information:
• In the OSPF Area ID field, enter 0.0.0.1.
• In the OSPF Admin Mode field, select Enable.
d. Click Apply to save the settings.
7. Configure area 0.0.0.1 as an NSSA area.
a. Select Routing > OSPF > Advanced > NSSA Area Configuration.
A screen similar to the following displays.
b. Enter the following information.
• In the Area ID field, enter 0.0.0.1.
• In the Import Summary LSA’s field, select Disable.
c. Click Add to save the settings.
CLI: Configure Area 1 as an NSSA Area on A2
1. Enable routing on the switch.
2. Set the router ID to 2.2.2.2.
3. Configure the area 0.0.0.1 as an NSSA area.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#router ospf
(Netgear Switch) (Config-router)#router-id 2.2.2.2
(Netgear Switch) (Config-router)# area 0.0.0.1 nssa