NETGEAR M4200

SNMP
455
Managed Switches
A screen similar to the following displays.
b. For Link Up/Down, select the Enable radio button.
c. Click Apply.
SNMP Version 3
The example is shown as CLI commands and as a web interface procedure.
CLI: Configure SNMPv3
(Netgear Switch) #config
(Netgear Switch) (Config)#users passwd admin
Enter old password:
Enter new password:12345678
Confirm new password:12345678
Password Changed!
change the password to “12345678”
(Netgear Switch) (Config)#users snmpv3 authentication admin md5
Set the authentication mode to md5
(Netgear Switch) (Config)#users snmpv3 encryption admin des 12345678
Set the encryption mode to des and the key is “12345678”