CoS Queuing
228
Managed Switches
Now 1/0/2 appears in the Interface field at the top.
d. Enter the following information:
• In the Minimum Bandwidth field, enter 25.
• In the Scheduler Type list, select Strict.
e. Click Apply to save the settings.
Set CoS Trust Mode for an Interface
The example is shown as CLI commands and as a web interface procedure.
CLI: Set CoS Trust Mode for an Interface
Note: The traffic class value range is 0–-6 instead of 0–-7 because queue 7
is reserved in a stacking build for stack control, and therefore you
cannot configure it.
Web Interface: Set CoS Trust Mode for an Interface
1. Select QoS > CoS > Advanced > CoS Configuration.
A screen similar to the following displays.
2. Under CoS Configuration, select the Interface radio button.
3. In the Interface list, select 1/0/3.
4. In the Interface Trust Mode list, select trust dot1p.
5. Click Apply to save the settings.
(Netgear Switch) (Interface 1/0/3)#classofservice trust?
dot1p Sets the Class of Service Trust Mode of an Interface
to 802.1p.
ip-dscp Sets the Class of Service Trust Mode of an Interface
to IP DSCP.
(Netgear Switch) (Interface 1/0/3)#classofservice trust dot1p?
<cr> Press Enter to execute the command.
(Netgear Switch) (Interface 1/0/3)#classofservice trust dot1p
To Next Page
Loading...
