Tools
413
Managed Switches
2. Activate image2.
a. Select Maintenance > File Management > Dual Image Configuration.
A screen similar to the following displays.
b. Under Dual Image Configuration, select the check box next image 2.
The Image name field in the table heading displays image 2.
c. From the Next Active Image menu, select True.
d. Click the Apply button.
Your settings are saved.
Outbound Telnet
In this section, the following examples are provided:
• CLI: show network
• CLI: transport output telnet
• Web Interface: Configure Telnet
• CLI: Configure the Session Limit and Session Time-out
• Web Interface: Configure the Session Time-out
Outbound Telnet:
• Establishes an outbound Telnet connection between a device and a remote host.
• A Telnet connection is initiated, each side of the connection is assumed to originate and
terminate at a network virtual terminal (NVT).
• Server and user hosts do not maintain information about the characteristics of each
other’s terminals and terminal handling conventions.
• Must use a valid IP address.
To Next Page
Loading...
