Security Management
346
Managed Switches
Enter Static Binding into the Binding Database
You can also enter the static binding into the binding database.
CLI: Enter Static Binding into the Binding Database
1. Enter the DHCP snooping static binding.
2. Check to make sure that the binding database has the static entry.
Web Interface: Enter Static Binding into the Binding Database
1. Select Security > Control > DHCP Snooping > Binding Configuration.
A screen similar to the following displays.
2. Fill in the fields for the static binding and click Apply.
3. Check to make sure that the binding database shows the entry in the Static Binding
Configuration table.
(Netgear Switch) (Config)# ip dhcp snooping binding 00:11:11:11:11:11
vlan 1 192.168.10 .1 interface 1/0/2
(Netgear Switch) #show ip dhcp snooping binding
Total number of bindings: 2
MAC Address IP Address VLAN Interface Type Lease (Secs)
----------------- -------------- ----- ---------- ------- -----------
00:11:11:11:11:11 192.168.10.1 1 1/0/2 STATIC
00:16:76:A7:88:CC 192.168.10.89 1 1/0/2 DYNAMIC 86348
To Next Page
Loading...
Need help?
General