iSCSI
676
Managed Switches
Enable iSCSI Awareness with DSCP
The example is shown as CLI commands and as web interface procedure.
CLI: Enable iSCSI Awareness with DSCP
Use the following commands to enable iSCSI awareness, select DSCP, and set DSCP queue
number and aging time.
Web Interface: Enable iSCSI Awareness with DSCP
1. Enable iSCSI awareness, select DSCP, and set the DSCP queue number and aging
time.
a. Select Switching > iSCSI > Basic.
A screen similar to the following displays.
b. Enter the following information:
• Next to iSCSI Status, select the Enable radio button.
• Next to QoS Profile, select the DSCP radio button.
• From the DSCP menu, select 46 (the default value).
• Next to Remark, select the Enable radio button (the default value).
• In the iSCSI Aging Time field, enter 10 (the default value).
2. Click Apply to save the settings.
(Netgear Switch) #config
(Netgear Switch) (Config) #iscsi enable
(Netgear Switch) (Config) #iscsi cos dscp 46
(Netgear Switch) (Config) #iscsi aging time 10
(Netgear Switch) (Config) #exit
To Next Page
Loading...
