NETGEAR M4200

Syslog
430
Managed Switches
Web Interface: Configure Logging for the Port
1. Select Monitoring > Logs > Sys Log Configuration.
A screen similar to the following displays.
2. Enter the following information:
• In the Host Address field, enter your host address 192.168.21.253.
• In the Port field, enter 4.
• In the Severity Filter list, select Alert.
3. Click Add.
(Netgear Switch) (Config)#logging host 192.168.21.253 4 ?
<cr> Press Enter to execute the command.
<severitylevel> Enter Logging Severity Level (emergency|0, alert|1, critical|2,
error|3, warning|4, notice|5, info|6, debug|7).
(Netgear Switch) (Config)#logging host 192.168.21.253 4 1 ?
<cr> Press Enter to execute the command.
(Netgear Switch) (Config)#logging host 192.168.21.253 4 1
(Netgear Switch) #show logging hosts
Index IP Address Severity Port Status
----- ----------------- ---------- ---- -------------
1 192.168.21.253 alert 4 Active