NETGEAR M4200

DHCPv6 Server
480
Managed Switches
3. Enable the IPv6 DHCP server on interface 2/0/21.
Note: In this case, you must configure the ipv6 nd other-config-flag
command on the interface, otherwise the host cannot update the DNS
server.
Web Interface: Configure a Stateless DHCPv6 Server
1. Enable ipv6 routing.
a. Select Routing > IPv6 > Basic > Global Configuration.
A screen similar to the following displays.
b. For IPv6 Unicast Routing, select the Enable radio button.
c. Click Apply to save the settings.
2. Enable IPv6 routing on interface 2/0/21.
a. Select Routing > IPv6 > Advanced > Interface Configuration.
(Netgear Switch) (Config)#interface 2/0/21
(Netgear Switch) (Interface 2/0/21)#routing
(Netgear Switch) (Interface 2/0/21)#ipv6 address 2003:1000::1/64
(Netgear Switch) (Interface 2/0/21)#ipv6 enable
(Netgear Switch) (Interface 2/0/21)#ipv6 nd other-config-flag
(Netgear Switch) (Interface 2/0/21)#ipv6 dhcp server ipv6_server
(Netgear Switch) (Interface 2/0/21)#exit