IGMP Snooping and Querier
281
Managed Switches
Show mac-address-table igmpsnooping
The example is shown as CLI commands and as a web interface procedure.
CLI for IGMPv1 and IGMPv2: Show mac-address-table
igmpsnooping
CLI for IGMPv3: show igmpsnooping ssm entries
(Netgear Switch) #show mac-address-table igmpsnooping ?
<cr> Press Enter to execute the command.
(Netgear Switch) #show mac-address-table igmpsnooping
Type Description Interfaces
----------------------- ------- -------------- -----------
00:01:01:00:5E:00:01:16 Dynamic Network Assist Fwd: 1/0/47
00:01:01:00:5E:00:01:18 Dynamic Network Assist Fwd: 1/0/47
00:01:01:00:5E:37:96:D0 Dynamic Network Assist Fwd: 1/0/47
00:01:01:00:5E:7F:FF:FA Dynamic Network Assist Fwd: 1/0/47
00:01:01:00:5E:7F:FF:FE Dynamic Network Assist Fwd: 1/0/47
(Netgear Switch) #show igmpsnooping ssm entries
VLAN Source
ID Group Source Ip Filter Mode Interfaces
---- ---------------------- ---------------------- ----------- --------------
1000 224.1.1.1 1.1.1.1 include 1/0/2
To Next Page
Loading...
