NETGEAR M4200

ACLs
184
Managed Switches
Use ACLs to Configure Isolated VLANs on a Layer 3 Switch
This example shows how to isolate VLANs on a Layer 3 switch by using ACLs. In this
example, PC 1 is in VLAN 24, PC 2 is in VLAN 48, and the server is in VLAN 38. PC 1 and
PC 2 are isolated by an ACL but can both access the server. The example is shown as CLI
commands and as a web interface procedure.
Figure 21. Using ACLs to isolate VLANs on a Layer 3 switch
Server
10.100.5.252
Port 11/0/38
10.100.5.34
Layer 3 switch
Port 1/0/24
192.148.24.1
Port 1/0/48
192.148.48.1
PC2
PC1
192.148.24.2 192.148.48.2