NETGEAR M4200 - Add a New Community

SNMP
453
Managed Switches
Add a New Community
The example is shown as CLI commands and as a web interface procedure.
CLI: Add a New Community
Web Interface: Add a New Community
1. Select System > SNMP > SNMP V1/V2 > Community Configuration.
A screen similar to the following displays.
2. In the Community Name field, enter public@4.
3. In the Client Address field, enter 0.0.0.0.
4. In the Client IP Mask field, enter 0.0.0.0.
5. In the Access Mode field, select Read/Write.
6. In the Status field, select Enable.
7. Click Add.
(Netgear switch) #config
(Netgear switch) (Config)#snmp-server community rw public@4