Switch Stacks
441
Managed Switches
CLI: Configure the 10G Copper Ports as Stack Ports
1. On Switch A, configure the stack port and reboot the switch.
2. After Switch A reboots, check the stack port configuration.
(Netgear Switch) #show stack-port
Configured Running
Stack Stack Link Link
Unit Interface Mode Mode Status Speed (Gb/s)
---- ---------------- ---------- ---------- ------------ ------------
2 0/25 Ethernet Ethernet Link Down 10
2 0/26 Ethernet Ethernet Link Down 10
2 0/27 Ethernet Ethernet Link Down 10
2 0/28 Ethernet Ethernet Link Down 10
(Netgear Switch) #
(Netgear Switch) #config
(Netgear Switch) (Config)#stack
(Netgear Switch) (Config-stack)#stack-port 2/0/28 stack
(Netgear Switch) (Config-stack)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch)#exit
(Netgear Switch) #reload
Management switch has unsaved changes.
Would you like to save them now? (y/n) y
Config file 'startup-config' created successfully.
Configuration Saved!
Are you sure you want to reload the stack? (y/n)y
(M4300-28G-PoE+) #show stack-port
Configured Running
Stack Stack Link Link
Unit Interface Mode Mode Status Speed (Gb/s)
---- ---------------- ---------- ---------- ------------ ------------
2 0/25 Ethernet Ethernet Link Down 10
2 0/26 Ethernet Ethernet Link Down 10
2 0/27 Ethernet Ethernet Link Down 10
2 0/28 Stack Stack Link Down 10
To Next Page
Loading...
