NETGEAR M4200

iSCSI
678
Managed Switches
Show iSCSI Sessions
The example is shown as CLI commands and as web interface procedure
CLI: Show iSCSI Sessions
Use the following commands to show iSCSI sessions and session details:
The command shows that there is an active iSCSI session. The initiator is at IP address
192.168.10.107 and the Target is at IP address 192.168.10.116
(Netgear Switch) #show iscsi sessions
Session 0:
--------------------------------------------------------------------------
Target: iqn.2012-08.com.example:storage.lun1
Initiator: iqn.1991-05.com.microsoft:netgear-think
ISID: 400001370000
(Netgear Switch) #show iscsi sessions detailed
Session 0:
--------------------------------------------------------------------------
Target: iqn.2012-08.com.example:storage.lun1
Initiator: iqn.1991-05.com.microsoft:netgear-think
Up Time: 00:00:04:11 (DD:HH:MM:SS)
Time for aging out: 382 secs
ISID: 400001370000
Initiator Initiator Target Target
IP Address TCP Port IP Address TCP Port
------------------- ------------- -------------------- -------------
192.168.10.107 57965 192.168.10.116 3260
(Netgear Switch) #