MAB
380
Managed Switches
The table heading displays the information for port 0/1.
c. Configure the following settings:
• From the Control Mode menu, select Force Authorized.
• From the MAB menu, select Disable.
Leave all other settings on the screen at their default value.
d. Click Apply.
5. Configure the port that connects to the IP phone (in this example, port 1/0/10) for MAB:
a. Select Security > Port Authentication > Advance > Port Authentication.
A screen similar to the following displays.
b. Select the check box that corresponds to port 0/10.
The table heading displays the information for port 0/10.
c. Configure the following settings:
• From the Control Mode menu, select MAC Based.
• From the MAB menu, select Enable.
Leave all other settings on the screen at their default value.
d. Click Apply.
Note: For information about how to reduce the MAB authentication time, see
Reduce the MAB Authentication Time on page 390.
To Next Page
Loading...
